Silicone Tubing for Sacrificial Layers (ID 15mm / OD 20mm) - per metre

Rating:
100%
€9.95
Lots in stock

Piece of silicone for reducing wear between rigging components, especially in case of steel on aluminium.

Sold per metre.

A sacrificial layer is a disposable layer, in this case made of silicone, that is put around a carabiner to protect your rigging from wear. Sacrificial layers help to keep your rigging safe by sacrificing themselves before damage is done to aluminium or nylon components. If a steel rigging component is connected to an aluminium or fabric one the movement in the system can cause the aluminium or fabric to wear away as it's not as hard as the steel. This wear can weaken the swivel/figure 8/sling and make your rigging less strong and therefore unsafe. This can be avoided by putting this layer of silicone tubing around one of the components. The silicone is pretty durable but will start to wear long before the aluminium or nylon is damaged. The sacrificial layer should be checked before each use. If worn through, the silicone sacrificial layer should be changed immediately. You should also check the carabiners and other components to make sure they remain undamaged. For more information about sacrificial layers read this article. The silicone tubing on this page is sold per metre. Its inside diameter is 15mm and its outside diameter is 20mm. The tubing is easy to cut with a sharp knife or pair of scissors and one metre will provide many sacrificial layers.
More Information
ManufacturerFiretoys.com Aerial
Country of ManufactureUK
Write Your Own Review
You're reviewing:Silicone Tubing for Sacrificial Layers (ID 15mm / OD 20mm) - per metre
Your Rating
We found other products you might like!
All text, images and animations are copyright © 2023 Firetoys Europe Limited | Registered in Ireland - Serving EU member states since 2003